Hyperflight Blaster 2 - Need more Information

To Next Page

To Previous Page

HyperFlight.co.uk Blaster 2 Assembly Guide

Trimming

Check for long flat glide from a fast hand launch in Launch Mode. Only very minor

AMT trim adjustment should be needed. If the rudder and flaperons have been set as

above, then NO adjustment should be required to these control surfaces. Gradually

increase launch speed to a hard “javelin” style launch. Make minor adjustments to

AMT launch trim as required until model climbs at about 30 to 40 deg from launch. At

this stage it is safer to work towards a trim where the launch angle gradually increases

from launch. ONLY NOW should you try the first Discus launch.

Need more information?

Try these Internet links and check out the July 2008 issue of Radio Control Model

World for the Blaster 2 DLG review.

144 more Blaster 2 DLG Build Pictures - http://www.photobox.co.uk/album/7656081

59 more Blaster 2 DLG Flying Pictures - http://www.photobox.co.uk/album/7655756

38 more Blaster 2 E Build Pictures - http://www.photobox.co.uk/album/7692097

Blaster 2 Thread on FlyQuiet Forum - http://www.flyquiet.co.uk/smf/index.php?topic=1037.0

Blaster 2 Electric Thread - http://www.flyquiet.co.uk/smf/index.php?topic=1079.0

Blaster 2 Electric Flying Video 1 - http://www.youtube.com/watch?v=Lg7wRCr_Xxk

Blaster 2 Electric Flying Video 2 - http://www.youtube.com/watch?v=AnCUPFbePNQ

Blaster 2 – Manufacturers web site - http://airplane-model.com/blaster2.html