HyperFlight.co.uk Blaster 2 Assembly Guide
A few build pictures to help you on your way!
(c) 2009 HyperFlight.co.uk, Drybank Farm, Ettington, Stratford upon Avon, Warks, CV37 7PD.
9
Fitting Fin/Rudder to Tail Boom
AMT Mount and Push Rod Tubes
Tape between Flaperon Halves
Fitting Fin/Rudder to Tail Boom
Cut out pre defined servo accesses Cut lugs off wing servos.
Servos wrapped and wing wiring Flaperon Links & Horn installed
Easiest way to cut slots for horns.
Possible Servo Installation 1
Possible Servo & Battery Position
Receiver & Regulator Positions
Possible Servo / Regulator Inst 2
Receiver on Underside of Mount.
To Next Page
Loading...