OPERATING INSTRUCTIONS
READ ALL INSTRUCTIONS BEFORE USING THE HYPERSPHERE MINI
CHARGING
Fully charge for two hours before irst use. To charge, connect the USB
cable from the charging port to any standard USB charger (not included).
LED lights illuminate to show battery level and indicate active charging. LED
lights will remain illuminated when fully charged while adapter is plugged
in. Unit may be recharged at any time and at any battery level. It is not
recommended to fully deplete the battery to the red LED level. Recharge the
unit monthly to best prolong battery life. The average run-time is 2 hours at
level three, and longer at lower levels.
OPERATING
To turn on, press down on the power button for three seconds until LED
lights illuminate. Press again once for level one, twice for level two and three
times for level three. The blue LED lights will indicate the corresponding
power level. Do not use directly on a hard surface. Use only on a carpeted
loor or a itness mat. To turn o, press down on the power button for three
seconds. The unit is fully turned o when all the LED lights are o.
The unit will turn o after 10 minutes of use. To continue use, turn unit on
again and set to desired level.
To Next Page
Loading...
