11
• “X” represents the number of DTCs found in the vehicle.
This screen will now appear:
• Press ‘Y’ to view the DTC(s) found in the vehicle. Press ‘N’ to
clear the DTC(s) without viewing them. If you press ‘Y’, these
screens will appear:
• Press the ‘N’ button to view the next DTC (if any). Once you
have viewed all the DTCs, this screen will appear:
• Press ‘Y’ to view the DTC(s) again. Press ‘N’ to continue.
If you press ‘N’, this screen will appear:
• Press ‘N’ to exit the program. This screen will appear:
• Press ‘Y’ for the Power Programmer to clear the DTC(s).
These screens will now appear:
VIEW DTCS = Y
CLEAR DTCS = N
DTC #1 --- PXXXX
NEXT DTC = N
NO MORE DTCS, TO VIEW AGAIN, PRESS Y
TO CONTINUE, PRESS N
DTCS MUST BE CLEARED BEFORE CHANGING PROGRAM. TO CLEAR DTCS PRESS Y
TO KEEP DTCS AND EXIT PROGRAM PRESS N
TURNING POWER
PROGRAMMER OFF
CLEARING DTCS
ALL DTCS HAVE
BEEN CLEARED
WRITE DOWN THE FOLLOWING DTCS AND REFER TO
FACTORY MANUALS FOR EXPLANATION
Hypertech, Inc. recommends proper diagnosis and repair of reported DTCs prior
to programming. For Diagnostic Trouble Code (DTC) interpretations, refer to
factory manuals, see your local parts dealer, or visit internet sites
that provide this type of information. An example of such a website is:
www.bentlypublishers.com/tech/vw/dtc.table.htm
IMPORTANT NOTE
To Next Page
Loading...
