Hyster C299 - Page 14

NOTE: Perform Step 24 through Step 43 for lift
truck model H8.0FT, H8.0FT9, H9.0FT (H170FT,
H175FT36, H190FT) (A299, B299, C299), .
24.
Remove drive axle main housing center fill plug
from main housing. See Figure 6.
25.
Remove right side and left side drain plugs
from drive axle. Drain oil into suitable con-
tainer. See Figure 6.
26.
Remove drive axle main housing center drain
plug from main housing, Drain oil into suitable
container. See Figure 6.
27.
Remove the parking brake cables. Refer to the
section
Brake System 1800SRM1247 for lift truck mod-
els
• H6.0FT, H7.0FT (H135FT, H155FT)
(H006, J006, K006)
Brake System 1800SRM1247 for lift truck mod-
els
• H8.0FT, H8.0FT9, H9.0FT (H170FT,
H175FT36, H190FT) (A299, B299)
.
Wet Brake System 1800SRM1977 for lift truck
models
• H6.0FT, H7.0FT (H135FT, H155FT)
(L006)
Wet Brake System 1800SRM1977 for lift truck
models
• H8.0FT, H8.0FT9, H9.0FT (H170FT,
H175FT36, H190FT) (C299)
.
NOTE: Note placement of hose clamps prior to re-
moval of hoses to aid in installation.
28.
Disconnect load sense in and load sense out
hose assemblies from accumulator charge
valve. See Figure 7.
29.
Disconnect brake line from modulating brake
valve. See Figure 7.
30.
Disconnect hydraulic pressure supply hose from
accumulator charge valve. See Figure 7.
31.
Disconnect hydraulic return hose from accumu-
lator charge valve and modulating brake valve.
See Figure 7.
Drive Axle Removal 1400 SRM 1344
8