Need help?Do you have a question about the Hyster H1.50XM and is the answer not in the manual?
Overview of engine specifications, including displacement, firing order, and cylinder arrangement.
Details procedures for removing and installing the engine, referencing other manual sections for specific models.
Covers checking the cylinder head for distortion and performing repairs as needed.
Details inspection of the rocker shaft assembly, including clearance checks and cleaning.
Procedures for checking the camshaft for cracks, wear, straightness, and journal clearances.
Describes how to measure valve stem to valve guide clearance and replace valve guides.
Explains how to inspect valve seats for cracks and check contact patterns for proper sealing.
Details how to inspect valves for wear, cracks, and measure stem diameter and head thickness.
Covers checking valve springs for damage, measuring free length, and checking squareness.
Covers inspecting the crankshaft for wear, cracks, straightness, and measuring journal diameters.
Details inspection of main bearings for damage and measuring bearing clearance using plastic gauge.
Covers inspecting pistons for wear and cracks, and measuring piston diameter and clearance.
Details measuring piston ring end and groove clearances for proper fit.
Explains how to check connecting rods for straightness and measure connecting rod bearing clearance.
Procedures for draining the cooling system, removing the thermostat housing, and testing thermostat operation.
Covers removal and disassembly of the fan assembly, including the belt and pulley.
Details the removal and installation procedures for the water pump and gasket.
Procedure for replacing the flywheel ring gear, including heating and installation steps.
To Next Page
General