Hytera MT680 Tetra - Call Services; TMO Individual Call

Error! Use the Home tab to apply 标题
1,Part,Document Header,Part1,Document
Header1,Part2,Document
Header2,Part11,Document
Header11,Part12,Document
Header12,Part21,Document
Header21,Part111,Document
Header111,Part3,Document
Header3,Part13,Document Header13,Part22
Owner’s Manual
22
8. Call Services
8.1 TMO
8.1.1
Individual Call
In TMO mode, an individual call can be initiated either as a half-duplex call or full-duplex call, which can
be received without pressing any key (Direct Signaling) or by pressing the Call key or PTT (Hook
Signaling). Contact your dealer for such programming as well as more details.
Initiating an Individual Call
z Via Menu
In the home screen, press Function/P1 key or OK key to enter the “PhoneBook” or “Call Log”
submenu, and select a contact. Then press PTT to initiate a half-duplex call, or press
to initiate
a full-duplex call.
z Via Manual Dial
In the home screen, input the number you want to call through the keypad, and select “Private No.”
through the OK key with the screen-icon
. Then press PTT to initiate a half-duplex call, or press
to initiate a full-duplex call.
Note:
¾ Entry of individual numbers must comply with the SSI&TSI dialing rules. See “SSI&TSI Dialing
Rules” in “Appendix” for more details.
¾
Calls will end automatically if the predefined call timer expires.
Answering an Individual Call
z Half-duplex Individual Call
¾ If it is an incoming call with Direct Signaling, you will hear the voices following an alert tone
automatically.