2
4. Basic Operations
Powering On/Off
Rotate the Radio On-Off/Volume Control knob clockwise/
counter-clockwise until a click is heard to turn the radio on/off.
Adjusting the Volume
After turning the radio on, rotate the Power On-Off/Volume
Control knob clockwise to increase the output sound volume, or
counter-clockwise to decrease it.
Adjust Power Level
With this feature, you may switch power levels quickly. Generally,
we recommend you to adopt low power for battery saving.
However, if you cannot communicate with radios located at a
distant place with low power, please select high power.
Press the programmed Adjust Power Level key to switch the Tx
power of the current channel between High and Low.
Selecting a Zone
A zone is a group of channels exhibiting the same property. You
can list such channels into a zone for convenient management to
them. The radio supports 3 zones: Zone 1, Zone 2 and Zone 3.
Each zone contains 16 channels at most.
You may quickly toggle to your wanted zone by pressing the
programmed Zone Up or Zone Down key. When toggling to a
zone, you will hear the alert tone for the zone (one alert tone for
Zone 1, two alert tones for Zone 2 and three alert tones for Zone
3).
Selecting a Channel
After turning the radio on, rotate the Channel Selector knob to
select a needed channel. You can also switch to the designated
channel by pressing the Preset Channel key.
If the Channel Notify function is active, you will hear the
corresponding channel number when switching to any channel.
Switching the Channel Mode
Each channel can be programmed as either analog channel or
digital channel via your dealer. If the current zone includes both
analog and digital channels, you may quickly switch between
digital and analog channels through the Channel Selector knob.
5. Call
To ensure optimal volume of the receiving radio, hold the palm
microphone approximately 2.5 to 5 centimeters away from your
mouth.
Private Call
Initiating a Call
In standby mode, hold the PTT key to transmit a private call to
the private call contact preset for the current channel.
Note: Your dealer may preset a contact for each
digital channel. The preset contact could be
a private call contact, a group call contact
or an all call contact.
Receiving a Call or Calling Back
When a private call is received, you can listen to it without any
operation. You may hold the PTT key within the preset time
period to call back.
To Next Page
Loading...
Need help?
General
