14
2. When the alarm tone disappears (None) or after the
Emergency ID is sent (HDC1200), you can speak into the
microphone to make an emergency call.
3. When the LED ashes orange, your radio is receiving.
Two methods are available for you to exit the Emergency mode:
1. After the preset Alarm Cycles and Voice Cycles expire, the
radio will exit the Emergency mode automatically. (None)
2. Long press the programmed Emergency key.
Call Only (HDC1200)
Operation:
1. Press the programmed Emergency key to go to the Revert
Channel, and the LED glows red.
2. If the feature “Alarm with Call to Follow” is enabled, you can
speak into the microphone to make an emergency call when
the LED glows red.
3. When the LED ashes orange, your radio is receiving.
To exit the Emergency mode, long press the programmed
Emergency key.
Note: Your dealer may set the number of alarm
cycles and alarm duration (None), number
of polite retries and impolite retries
(HDC1200), number of voice cycles, duration
of each transmission and TX interval.
Operation Method for Digital Emergency
Alarm
Operation: Press the programmed Emergency key to send alarm
information. At this time, the LED glows red.
Two methods are available for you to exit the Emergency mode:
1. Once the Alarm Cycles expire, the radio will exit the
Emergency mode automatically.
2. Long press the programmed Emergency key.
Alarm with Call
Operation:
1. Press the programmed Emergency key to send alarm
information. At this time, the LED glows red.
2. When the LED solidly glows red, you can speak into the
microphone to make an emergency call.
3. When the LED ashes orange quickly, you can receive. And
when a call is received, the LED glows green solidly.
4. If the preset Voice Cycles expire, you can press the PTT
key to make the emergency call again (the LED glows red).
Release the PTT to receive (the LED ashes orange quickly);
when a call is received, the LED glows green solidly.
To exit the Emergency mode, long press the programmed
Emergency key.
Call Only
Operation:
1. Press the programmed Emergency key to go to the Revert
Channel.
2. If the feature “Alarm with Call to Follow” is enabled, you can
speak into the microphone to make an emergency call when
the LED glows red.
3. When the LED ashes orange, your radio is receiving.
If the preset Voice Cycles expire, you can hold down the PTT
Functions and Operations
To Next Page
Loading...