EasyManua.ls Logo

Hytera PD70X - Emergency Mode

Hytera PD70X
27 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
13
Emergency ID Type
Your radio supports two Emergency ID types. You can select one
of them via your dealer:
Emergency ID Type Description
None
No signaling is used when the radio
sends alarm information.
HDC1200
HDC1200 signaling is used when the
radio sends alarm information.
Emergency Mode
Your radio supports three Emergency modes. You can select one
of them via your dealer (Note: For the following operation methods,
we take the “Regular” type as an example).
Emergency
Mode
Description
Alarm
In this mode, you can send alarm information
to your companion or control center by
pressing the programmed Emergency key,
but you cannot talk with them.
Alarm with
Call
In this mode, you can send alarm information
by pressing the programmed Emergency
key. When the alarm tone disappears (None)
or after the Emergency ID is sent (HDC1200),
you can speak into the microphone, allowing
your voice and background noise to be
transmitted automatically (you do not need
to hold down the PTT key).
Call Only
In this mode, press the programmed
Emergency key to go to the Revert Channel,
and speak into the microphone, allowing
your voice and background noise to be
transmitted automatically (you do not need
to hold down the PTT key).
Operation Methods for Analog Emergency
Alarm (None & HDC1200)
Operation: Press the programmed Emergency key to send alarm
information, and the LED glows red. (None: If “Local Emergency
Alarm” is enabled via the programming software, an alarm tone will
sound.)
The following methods are available for you to exit the Emergency
mode:
1. Once the Alarm Cycles expire, the radio will exit the
Emergency mode automatically.
2. Long press the programmed Emergency key.
3. Hold down the PTT key. The radio will transmit on the channel
on which the radio operates before entering the Emergency
mode. (HDC1200)
Alarm with Call (None & HDC1200)
Operation:
1. Press the programmed Emergency key to send alarm
information, and the LED glows red. (None: If “Local
Emergency Alarm” is enabled via the programming software,
an alarm tone will sound.)
Functions and Operations