on LCD. 00 bit on the left side of LCD indicates data cloning rate and increases at a
basic unit of one as data is continuously received.
6) The source radio flashes orange with “END” on LCD after the data transmission. Clone
frequency appears when [P1] is pressed. Repeat the above steps to continue cloning.
While the target radio reverts to Users Mode after receiving all data.
Note: Clone Mode can be enabled/disabled by your local dealer. Cloning is accessible
only when Clone Mode is enabled.
5. Firmware Version Display Mode
Press [P4] to power on the mobile radio and Firmware Version Display Mode appears
on LCD. Release [P4] to enter User Mode automatically.
6. PC Mode
Connect the mobile radio with PC via programming cable. The data can be written
to the radio from PC, and then saved into the EEPROM. Data programming and radio
adjustment are accessible by programming software.
1) “PROGRAMM” appears on LCD after data is transferred to the mobile radio from
the computer. LED glows green when data is written to the radio and red when data is
read from the radio. Radio will restart automatically when programming is completed.
2) The following parameters can be set through the programming software.
● High TX Power
● Low TX Power
● Maximum Frequency Deviation
● CDCSS Balance
● CTCSS Deviation
● CDCSS Deviation
● DTMF Deviation
● MSK Deviation
● Single Tone Deviation
● Rx sensitivity
● Squelch Level 9
● Squelch Level 3
To Next Page
Loading...
