Hytera TM-610 - Tuning Items and Display

41
without saving the data.
2-2 Enter Panel Tuning Mode
Press [P1] key to turn on the radio and LED flash red twice. Press [P4] to enter tuning
mode.
Within the adjustment items, all the frequency and signalling, other than the maximum
deviation and sensitivity, return to the values valid for the test frequency channel and test
signalling channel before entering the panel tuning mode.
No Dealer Mode
1 Tx high power
2 Tx low power
3 Max. Frequency Deviation
4 CDCSS balance
5 CTCSS Frequency Deviation
6 CDCSS Frequency Deviation
7 DTMF Frequency Deviation
8 MSK Frequency Deviation
9 Single Tone Frequency Deviation
10 Rx Sensitivity
11 Squelch on level
12 Squelch off level
Note: The tuning items display as the description in Section “2-3”
2-3. Tuning Items and Display
Setting Items and Display
Setting Items
Main LCD Wideband/
Narrowband
Frequency Sub-LCD Description
TX Power
TXHIGH
High power
Wideband
Certer _C *** No signalling
Low _L *** No signalling
High _H *** No signalling
TX LOW
Low power
Wideband
Center _C *** No signalling
Low _L *** No signalling
High _H *** No signalling
Max Deviation MAX.DEV
Wideband
Center _C *** No signalling
Low _L *** No signalling
High _H *** No signalling
Medium band Center M_C *** No signalling
Narrow band
Center N_C *** No signalling
Low N_L *** No signalling
High N_H *** No signalling