RCTA (Rear cross traffic alert)
When your vehicle drives backwards
after parking, the sensor detects any
approaching vehicles from the left
and right sides and gives information
to the driver.
Operating conditions
• When you press the BSD switch
with the ignition ON, the BSD indi-
cator illuminates and the system
turns ON.
• The system operates, when the
driving speed is below 6.2 mph (10
km/h) with the shift lever in
R(Rear).
• The RCTA sensing range is from
0.5m to 20m in accordance with
the directions.When the approach-
ing vehicle speed is from 2.5 mph
(4 km/h) to 22 mph (36 km/h) with-
in the sensing range, it will be
detected. However, the system
sensing range is varied in different
conditions. Always take a look
around the vehicle.
Warning type
• When the sensor detects any
approaching vehicles behind, the
warning light will flash on the out-
side rearview mirror with an warn-
ing alarm.
• When an approaching vehicle
behind is out of the sensing range,
when it drives away in the opposite
direction or when it drives slowly,
the warnings will be turned OFF.
• The system may not normally
operate due to certain factors.
Always take a look around your
vehicle.
❈ When the left- or right-side
bumper of your vehicle is blinded
by barriers or vehicles, the system
sensing performance may be
deteriorated.
5-62
Driving your vehicle
OVI055132NOVI055131N
To Next Page
Loading...
Need help?
General
