23
About Voice Recognition
Q
System cannot recognize my voice. What is the cause?
A_
1
When start voice recognition, you can hear BEEP sound after system
saying “Please say a command after the beep”. System recognizes your
voice after this BEEP sound, for this reason when overlap BEEP sound
and voice, system cannot recognize. Please wait and say after the
BEEP sound.
A_
2
This system can recognize already defined commands. You can find
these commands on the screen and Voice Recognition session in
Owner’s Guide.
Q
System cannot recognize “Call John Smith”. What is the cause?
A_
1
To call by name using voice recognition, please check these required
conditions.
1. Connect the Bluetooth phone.
2. Contacts are downloaded.
3. Check if the name is stored on the downloaded contacts.
(ex: John Smith)
A_
2
When you say “Call John Smith”, “John Smith” has to be stored in
downloaded contacts. If “John Smith” is stored named “My Friend”
system cannot recognize “Call John Smith” instead of “Call My Friend”.
H_VI_고급1.0[USA_N] QRG.indd 23급1.0[USA_N] QRG.indd 23 2015-04-07 오전 9:39:452015-04-07
To Previous Page