DO-IT-YOURSELF MAINTENANCE
6-16
B760A07HP-1
4. Remove the filter cover by pulling it.
B760A06HP-1
5. Replace the two filters.
6. Installation is the reverse order of disassem-
bly.
1. Open the glove box and take out the damper
strap from the hole.
2. Lower the glove box completely by pushing
the both sides of the glove box inward.
B760A03HP-1
B760A01HP
3. Pull out the pin fixing the filter cover after
pushing it to the left and fix the pin to the
groove on the filter cover.
groove
anymore than 8.0 mm. If you have the instru-
ments to check it with a force of 98N (22 lb.),
the deflection should be approx. 8.0 mm (0.315
inches). If the belt is too loose, have it adjusted
by your Hyundai dealer.
NOTE:
The compressor drive belt tension for diesel
engine (2.9 CRDi only) is adjusted automati-
cally.
B145A03HP-GAT
CHANGING THE AIR CONDITIONER
FILTER (For Evaporator and Blower
Unit) (If installed)
The air conditioner filter is located in front of the
evaporator unit behind the glove box. It helps to
the amount of decrease pollutants entering the
car.
B760A02HP
To Next Page
Loading...
Need help?
General
