I-GO Crest CSS User Manual

PAGE 13
To adjust the armrest angle:
5.3 ADJUSTING THE SEAT
To adjust the armrest width:
5. OPERATION
1. Loosen the knobs.
2. Slide the armrests in or
out to the desired width.
3. Tighten the knobs.
knobs
To adjust the height of armrests:
1. Lift up the armrest.
2. Loosen the hex nut.
3. Adjust the socket screw up or down
to the desired arm angle position.
4. Tighten the hex nut.
5. To determine the same angle for
the opposite armrest, count the
exposed threads after the hex nut
has been tightened.
6. If necessary, repeat the steps for
the opposite armrest.
1. Loosen knob on handle.
2. 
3. Tighten knob.
Hex
Knob Armrest

I-GO Crest CSS Specifications

General

Brand	I-GO
Model	Crest CSS
Category	Wheelchair
Language	English