23
8
Cautions and Troubleshooting:
Cautions:
Do not use a power supply that is over 3 Volts (DC in). Be
aware that failing to comply with this warning can damage
the internal components of the camera as well as putting
you at risk of an electric shock / fire.
Only use I/OMagic approved power supplies with the camera.
Do not use excessive force to pull or twist the adapter cable
or connector.
Before disconnecting the cord, make sure the camera is
turn off.
Make sure you turn off the camera and disconnect any
power supply when the camera is not in use.
Keep camera equipment away from the elements
(Excessive Heat or Cold) to ensure proper operation.
Remove the batteries from the camera when it will not be
used for long period of time.
No RS-232C cable longer than 3 m shall be connected to
the camera when used with PC.
Troubleshooting:
The following section describes common problems
you may encounter, along with some suggestions on how
to resolve them. Please follow any instructions carefully
and step by step.
To Next Page
Loading...