26
LCD Display
Panel
messages
No. display in the LCD
Wrong image showed
Mark is blinking
and power automatically
cuts off after 5 seconds.
Mark shown
Mark is blinking
“FULL” is shown
“E1” is shown
“E2” is shown
Measures to be taken
1.Please check if the positive and
negative polarity is set correctly.
2.Please check if batteries are drained.
Batteries become weak, please
prepare new batteries for replacement.
Batteries are too low to run the
camera,please replace with new
batteries.
Batteries become weak, please
prepare new batteries for replacement.
There is no memory card inserted,
please insert it.
Memory card is full, please delete
the images stored, or replace the
memory card (if you have additional
memory cards).
1.The data in the memory card might
be out of order. Please use “ERASE
ALL” to format the memory card, and
try again.
2. If “E1” still shown, the memory card
might be damaged. Replace the
memory card with a new one and try
again.
Memory card protected, please remove
the tag on the memory card.
To Next Page
Loading...