Caution
Do not pierce cabinet as internal damage may occur to electrical and hydronic components.
Caution
The air handler must be installed so that electrical components are not exposed to water
during operation.
Note
All wiring on IBC air handlers must adhere to the National Electrical Code and/or local
regulations.
Note
All units conform to CSA C22.2 NO. 236-15 and UL 1995 Stds. Water coil conforms to NSF /
ANSI Std. 372.
Important safety instructions
Failure to read and comply with all instructions and applicable national and local codes may result in
hazardous conditions that could result in property damage and injury to occupants, and in extreme cases
to death. Keep instructions near the air handling unit for future reference.
When using electrical appliances, follow safety precautions to reduce the risk of fire, electric shock, or
injury to persons, including:
Install or locate the air handling unit only in accordance with the provided installation instructions.
Use the air handling unit only for its intended use as described in this manual.
Do not operate the air handling unit if it is not working properly, or if it has been damaged or
dropped.
Installation, start-up and servicing of IBC's air handling units must be done with care and attention,
and should only be performed by competent, qualified, licensed and trained plumbing and
heating technicians. Contact your nearest authorized service facility for examination, repair, or
adjustment.
If subjected to flooding, the unit must be replaced.
Section: Safety information
To Next Page
Loading...
Need help?
General
