Annual Maintenance Check
Check the Error Logs for any issues.
□
Inspect the flue gas exhaust and air intake connections. All connections should be tight and
leak free.
□
Inspect flue gas exhaust piping, combustion air piping and terminations.
□
Inspect the boilers interior and vacuum if required.
□
Check for water, gas and condensate leaks in the boiler and around the boiler.
□
Check the condensate trap and clean if required. Re-fill the trap and re-install the trap hook.
□
Check the water pressure, expansion tank and pumps.
□
Check the electrical connections.
□
Check the ignition electrode and remove oxidation from the electrode. Replace if necessary.
□
Check the gas valve and ignition cable.
□
Check the controller settings.
□
Check the burners flame. Should be a quick and quiet ignition across the full burner.
□
If required, clean the heat exchanger and the burner. Refer to instructions in the boiler's
Installation and Operating Instructions manual
□
Note
Installers should inquire of local water purveyors as to the suitability of their supply for use in
hydronic heating systems.
If water quality is questionable, a local water treatment expert must be consulted for testing,
assessment and, if required, treatment.
Alternatively, water or hydronic fluid of known quality can be brought to the site.
To Next Page
Loading...
Need help?
General
