To Next PageTo Next Page
Need help?Do you have a question about the IBC IBGFSW1-0199 and is the answer not in the manual?
Explains the meaning of danger, warning, caution, and note symbols.
General safety guidelines for installation, service, and operation.
Lists corrosive contaminants to avoid for boiler longevity.
Provides physical dimensions for VX 110, VX 150, and VX 199 models.
Details required pipe sizes and types for various connections.
Highlights key features like high thermal efficiency and easy-to-use touchscreen.
Outlines residential and commercial warranty terms for parts and heat exchanger.
Checklist of precautions to review and observe before installing the appliance.
Specifies installation compliance with Canadian and US codes.
Procedures and checks when replacing an old boiler.
Guidelines for selecting a suitable installation location and environment.
Instructions for securely attaching the boiler to the wall structure.
Details on connecting PVC/CPVC/PPs pipe for venting and air intake.
Specifies minimum distances from combustible surfaces and for service access.
Guidelines for vent material, options, and termination types.
Step-by-step guide for installing the condensate trap assembly.
Procedures for installing a condensate neutralizer if required.
Best practices and guidelines for water piping connections.
Requirements for gas supply pressure and pipe sizing.
Guidelines for wiring the boiler according to electrical codes.
Details the controller's startup sequence and self-diagnostic features.
Describes the touchscreen interface, its response, and status indicators.
Checklist for electrical, ducting, and water connections before operation.
Procedure for safely starting and stopping the boiler.
Steps to test the safety function that prevents ignition failures.
Procedures for initial setup, fuel conversion, and gas valve adjustment.
Basic checks the owner should perform regularly.
Detailed maintenance tasks for qualified technicians.
Maintenance tasks for components like the condensate trap, burner, and heat exchanger.
Guidance on troubleshooting sensors, fan, water pressure, and SIM module.
Explains common error codes, diagnoses, and fixes displayed on the controller.
Covers issues like sensor errors, airflow, pressure, and controller status.
Diagnoses and fixes for problems related to boiler ignition.
Addresses problems with low heat, overheating, and zone heating.
Solutions for rapid cycling and other operational anomalies.
General
