Qscan User’s Guide Version 1.4
Page 19
Symbology Setup 7
X007 a b c d e f g h
a Bookland 0=off 1=on
b Postbar 0=off 1=on
c Macro Pdf (2d) 0=off 1=on
d UCC coupon 0=off 1=on
e unused always 0
f unused always 0
g unused always 0
h unused always 0
Use this command to turn the listed symbologies and features on or off.
PROGRAMMING
BARCODE
Length Settings for 2 of 5 Symbologies
X040 aa bb cc dd ee ff
aa I 2 of 5 length 1 2 digit length 00=any length
bb I 2 of 5 length 2 2 digit length 00=any length
cc M 2 of 5 length 1 2 digit length 00=any length
dd M 2 of 5 length 2 2 digit length 00=any length
ee D 2 of 5 length 1 2 digit length 00=any length
ff D 2 of 5 length 2 2 digit length 00=any length
Because of the structure of 2 of 5 barcodes, it is possible that reading
only part of the barcode will result in a valid decode, with undesired
results. To suppress this problem, it is best to use check digits with 2 of
5 symbologies (if available) or restrict the lengths for these barcodes so
that partial decodes cannot occur. You can program up to two different
lengths for each of the supported 2 of 5 symbologies. If you prefer to
leave it wide open, then you can set the lengths to 00.
To Next Page
Loading...