1-11
BOILER SYSTEMS AND OPERATION
CONTROLLER MANUAL – SFC/SFB SERIES BOILERS
See below for a description of the codes:
Table 2: Information menu
ACCESSING INSTALLER MENU TO
CHANGE CONTROLLER PARAMETERS
The Installer Menu allows installers to change controller parameters set out in
table 3 on pages 1-13 to 1-16.
You can access these parameters through the installer’s code 015. The
installer’s code is shown on the left numerical display after the letter C. The
parameters are also shown on the left numerical display, after the letter P.
To Next Page
Loading...
