Operating Instructions
● Bluetooth Pairing Mode:
Press MODE button on the unit or the remote control until BLUETOOTH is selected.
1). Put the cell phone within 3 meters;
2). Activate the Bluetooth features on your cell phone so that the cell phone starts to search for the Bluetooth device. Please
refer to the users’ manual for details
3). Select “FREESOUND” from the device found by the cell phone;
4). For some cell phones, the users have to key in the identification code “0000” and press ENTER key to pair the unit and cell
phone.
5). Press RETURN key on the cell phone to exit from the cell phone menu and play music with the unit when there is no barrier
between two cell phones within 10 meters. At this time, you can play music with the unit.
6). Shortly press PLAY/PAUSE button to play or pause music. Short press “ ” or “ ” key to select the previous or next track.
● FM (radio) Mode:
Press MODE button shortly after startup to switch over to “FM” status.
Auto radio station search and storage: Long press on the PLAY/PAUSE button and the unit will automatically search for radio
stations in the radio frequency range between 87.5 and 108.0 MHz. 20 radio stations may be stored. Press a number button on
the remote to access directly a stored radio station.
●LINE IN MODE:
Press MODE button on the unit or the remote control until LINE is selected. Play the music of the device connected to the LINE
input (4) on the rear panel.
● USB Mode:
1. After startup, press MODE to select “USB” and insert the USB device. The unit will automatically read and play the music in
the USB device.
2. Press “ ” key shortly to pause or play the track.
3. Shortly press “ ” key to skip to the previous track.
4. Shortly press “ ” key to skip to the next track.
● SD Mode:
1. After startup, press MODE to select “SD” and insert the SD card. The unit will automatically read and play the music in the SD
card.
2. Press “ ” key shortly to pause or play the music.
3. Shortly press “ ” key to skip to the previous track.
4. Shortly press “ ” key to skip to the next track.
Specifications
AC100~240V(±10%)~ 50/60Hz
The product design and specifications may be changed without prior notice!
Troubleshooting
No sound output
when power on
1: No input sound source
2: Volume knob in the lowest position
3: USB/SD no plug
1:Connect a Line signal
2: Adjust volume
3: Insert a USB/SD Card
1:Volume too loud
2: Audio file error
1:Turn volume lower
2:Check and change the audio file
To Next Page
Loading...
Need help?
General
