c9pu298
5. Connect the power cords to printer and 2000-sheet finisher and power source.
Note: A power cord is not supplied with 2000-sheet finisher.
6. After the printer warms up, the READY message displays on the operator panel.
Note: If message display area shows solid rectangles, make sure the I/O cable is
attached firmly to both the 2000-sheet finisher and the printer. Also make sure the
I/O cable connectors are plugged into the appropriate connector.
Important
To confirm that you have correctly installed the 2000-sheet finisher, print a
configuration page. The report will list the 2000-sheet finisher. See “Example 1 —
Printing the Printer Configuration Page” on page 32.
Installing a Staple Cartridge
Follow these steps:
1. Turn printer and 2000-sheet finisher power off.
2. Unplug the printer and the 2000-sheet finisher power cords.
3. Open the stapler cover (1) and review the instructions on the inside of the stapler
cover.
Chapter 7. Installing Printer Options 191
To Next Page
Loading...
