IBM 5100 - MAP Example

(
(
(-'
J
2
011
TAPE READ MAP
PAGE
3 OF
45
Use the keys in the numeric key section.
-Hold CMD and press * (BASIC multiply key).
OR
-Hold CMD and press x (APL mUltiply key).
You have now put the DCP1 program In
diagnostic mode.
If the diagnostic mode load IS ok, the characters
DIAG DCP1 are displayed (refer to section 3,
diagnostic aids).
Are the characters DIAG DCP1 displayed?
V N
012
Is the PROCESS CHECK light on?
V N
013
Go to MAP 0900, Entry Point A.
014
Go to MAP 0420, Entry Point A.
015
Use the keys In the numeric key section.
-Press C
-Hold CMD and press 1
-Press EXECUTE
You have loaded and are
running the tape read
diagnostic (refer to section 3, diagnostic aids).
-Follow the instructions displayed to run the
diagnostic. If the PROCESS CHECK light comes
on or the characters DCP2 are displayed:
Go to Page 1, Step 001, Entry Point A.
o E F G
2 222
MAP 0300-3
016
Go to MAP 0900, Entry Point A,
017
Go to Page 1, Step 001, Entry Point A.
018
An error instruction is displayed In the
following format:
GOTO MAP 0300 ERROR XXX.
Is your answer to the displayed question
an error instruction?
V N
019
Do not press EXECUTE ,R ,or L unless
asked to.
Follow the instructions displayed
on this display.
NOTE:
After you follow the instructions on
this display another display might appear,
Ignore this next display.
Go to Page 1, Step 001, Entry Point A.
020
Go to Page 4, Step 024, Entry Point G.
021
Are you diagnosing an internal tape drive
problem?
V N
022
Go to MAP 0200, Entry Point A.
023
Run the tape write diagnostic program by
following the instructions displayed.
28SEP76
PN 1608386
EC 829670 PEC 828851
MAP 0300-3
•