Completing the Installation
What to do next?
Installing an external option? — Go to “Connecting External
Options” on page 270.
No external options to install?
– If you installed options during the initial setup of your
server, go to Chapter 2, “Installing Software” on page 21 to
complete the installation procedure. Then return here.
– If you installed hot-swap drives, you might need to update
your server configuration parameters.
If your server is a disk-array model, go to Chapter 3,
“Configuring the Disk Array” on page 77 to see if you need
to update your RAID configuration information, and then go
to Chapter 6, “Configuring Your Server” on page 279 for
additional details about configuration.
If your server is a non-disk-array model, go to Chapter 6,
“Configuring Your Server” on page 279 to see if you need
to configure your server.
– If you removed memory modules or internal drives, you
must run the Setup program. See “Using the Setup
Program” on page 281 for instructions.
– If you removed an ISA or EISA adapter, you must run the
EISA Configuration program. See “Using the EISA
Configuration Diskette” on page 295 for instructions.
– Device drivers to install? (The instructions that come with
the option will tell you if device drivers are required and
how to install them.) If you do not need to install any
device drivers or configure the system, your server is ready
to use.
Chapter 5. Installing Options 269
To Next Page