Using the SCSISelect Utility Program
The SCSI-2 Fast/Wide PCI Adapter on a non-disk-array model has a
built-in menu-driven configuration utility program that allows you
to view and change SCSI settings.
You can use the SCSISelect Utility program to:
Change the default values
Verify and change configuration conflicts
Format a new SCSI hard disk
Starting the SCSISelect Utility Program
You can access this program when you start your non-disk-array
server. The SCSISelect prompt appears after the IBM PC Server
screen. Press Ctrl+A immediately after the SCSISelect prompt
appears.
Use the Up Arrow (↑) or Down Arrow (↓) key to move the
highlight bar to the various menu choices. Press Esc to return to the
previous menu. Also, you can press F5 to switch between color and
monochrome modes (if your monitor permits). To change the
current settings of the items displayed in the menus, follow the
directions on the screen.
SCSISelect Utility Program Options
The following options appear on the SCSISelect Utility program
menu:
Configure/View Host Adapter Settings
SCSI Disk Utilities
Chapter 6. Configuring Your Server 303
To Next Page