Installing PeerMaster LAN Software
To update the system files, do the following steps:
1. Insert the PeerMaster Server Adapter Option Diskette into the
diskette drive of a workstation attached to your server.
2. Compare the file dates of the NLM files on your PeerMaster
Server Adapter Option Diskette with the dates of the same files
located in the SYS:\SYSTEM directory of your server. If the
specified file does not already exist, or if it is an old version,
replace the file with the newer version provided on the
PeerMaster Server Adapter Option Diskette.
Note: To copy a file, you might require supervisor access to
your server. Some files might be restricted to read-only
access. You must alter the attributes of such files to
successfully overwrite them.
After you copy the system files to your server, you will no longer
have to manually load system files from your DOS partition.
Filename
Novell
NetWare 3.11
Novell
NetWare 3.12
Novell
NetWare
4.x
MONITOR.NLM replace
LSLENH.NLM replace
MSM.NLM replace
MSM31X.NLM replace replace
ETHERTSM.NLM replace replace
PATCHMAN.NLM replace
Unloading the Network Device Drivers
Using Novell NetWare, you can unload LAN device drivers after
they are loaded and operational. When both MXPCI4BT.LAN and
VNET.LAN are loaded, it is important to unload VNET.LAN first,
then unload MXPCI4BT.LAN. When you unload a device driver, all
ports controlled by that device driver will become unbound from
the protocol stack. Specific named instances of the device driver
may not be selectively unloaded.
48 PC Server 520 User's Handbook for PCI/EISA
To Next Page
Loading...
