and connecting the cables” on page 38 (desktop model), or “Replacing the
cover and connecting the cables” on page 52 (microtower model).
7. Restart the computer, leave it on for about ten seconds, and then turn off the
computer. You will hear beeps.
8. Repeat steps 2 through 4 on page 55.
9. Move the jumper back to the standard (pins 1 and 2).
10. Replace the cover and connect the power cord. See “Replacing the cover and
connecting the cables” on page 26 (small desktop model), “Replacing the cover
and connecting the cables” on page 38 (desktop model), or “Replacing the
cover and connecting the cables” on page 52 (microtower model).
Chapter 6. Updating the computer configuration 57
To Next Page
Loading...
