Need help?Do you have a question about the IBM RS/6000 44P 170 and is the answer not in the manual?
General| Processor | PowerPC 604e |
|---|---|
| Hard Drive Interface | SCSI |
| Operating System | AIX |
| Form Factor | Desktop |
| Graphics | Integrated |
| Expansion Slots | PCI |
| Ports | USB, Serial, Parallel, SCSI |
Instructions for removing the system unit from its packaging and initial checks.
Procedures for removing and replacing the system unit's side cover.
Instructions and precautions for removing and replacing the system battery.
Steps for removing and installing memory modules on the system board.
Procedures for removing and installing the system's processor card.
Instructions for removing and installing expansion adapters in the system.
Information and procedures related to internal disk and media drives.
Steps for removing and installing disk drives within the system unit.
Procedures for removing and installing CD-ROM and tape drives.
Guidelines for using and preparing optional media bays and drives.
Instructions for updating the system's firmware and checking current levels.
Pre-procedure checks and requirements for system verification.
Steps on how to load the system's diagnostic software.
Detailed steps to perform the system verification test.
Procedures for conducting further system verification checks.
Instructions on how to properly shut down and exit diagnostic procedures.
Important safety precautions to follow during installation procedures.
Precautions for handling components sensitive to electrostatic discharge.
Procedure for safely shutting down the system before maintenance.
Procedures for removing and replacing the system unit's covers.
Instructions for removing and replacing the system unit's cover support bridge.
Steps to remove and replace the system battery.
Detailed steps for removing and installing memory modules.
Procedures for removing and installing the processor card.
Instructions for removing and installing various system adapters.
Information on internal drives, handling, configuration, and unconfiguration.
Steps for removing and installing disk drives.
Procedures for installing and removing media drives.
Guidelines for preparing and using optional media bays.
Steps for installing an optional disk drive into the media bay.
Instructions for installing an optional media fan assembly.
Information on updating system firmware and checking current levels.
FCC compliance statement for the device, detailing interference limits.
EU electromagnetic compatibility compliance statement.
Compliance statement for IEC standard 950.
UK safety requirements for indirect connection to public telecommunication networks.
Canadian compliance statement for Class B digital apparatus.
Official Canadian compliance statement for digital apparatus.
Japanese VCCI statement regarding radio interference control.
German statement regarding radio protection compliance.
Information on environmentally sound disposal and recycling of product materials.
Details on IBM's environmental considerations and efforts in product design.
Section to record system product name, serial number, and key serial number.
Tables for recording installed internal and external system options and devices.
Diagram and table illustrating SCSI IDs and bay locations for internal devices.
Default general attributes for diagnostic programs on TTY terminals.
Setting for cursor movement to the next line after reaching the end of the current line.
Controls tab behavior and its dependency on field attribute character positions.
Controls tab behavior and its dependency on field attribute character positions.
Manages data transfer to auxiliary port during diagnostics without disturbing main communications.
Communication settings for terminals like 3151, 3161, and 3164.
Keyboard setup attributes for terminals like 3151, 3161, and 3164.
Printer setup attributes for terminals like 3151, 3161, and 3164.
To Next Page
