Step 11: Connect Additional External SCSI Devices
1. Locate the last SCSI device in the chain from the system unit. Remove the SCSI
device terminator (if it is installed).
2. Connect the new SCSI cable where you just removed the SCSI device terminator.
3. Connect the other end of the SCSI cable to the new SCSI device.
4. Connect the SCSI device terminator.
5. Repeat the above steps for each additional SCSI device you attach.
6. Refer to the SCSI device documentation to set the SCSI device address. For future
reference, you can record the address in “Appendix D. System Records” on
page 61.
Chapter 1. Setting Up the RS/6000 44P Series Model 170 7
To Next Page
Loading...
