IBM RS/6000 44P 170 - Appendix C. Notices

6. Remove the chassis blank by grasping the tabs and pushing downward while
pulling outward.
7. If you ordered the optional disk drive carrier, do the following:
a. Remove the screws that secure the disk drive carrier to the system unit
chassis.
b. Remove the disk drive carrier.
8. Push the SCSI and power cables out the front of the system unit.
9. If you are installing optional media, go to “Installing Optional Media” on page 48
10. If you are installing optional DASD, go to “Installing an Optional Disk Drive” on
page 48
Optional Media Device
(Customer Purchased Option)
Optional Media Device
(Customer
Purchased Option)
Bezel BlankBezel
Blank
Chassis BlankChassis
Blank
Optional Disk Drive Carrier
(Customer Purchased Option)
Optional Disk Drive Carrier
(Customer
Purchased Option)
Customer Purchased
Optional Disk Drive
Customer
Purchased
Optional
Disk Drive
Chapter 3. Installing Options for the RS/6000 44P Series Model 170 47