Changing the Paper Exit Location
21Operator’s Guide
Setting Top Paper Exit
Use this procedure to change the pedestal
printer from rear exit to top exit.
Press Stop to place the printer in
NOT READY state.
If there is paper in the printer, unload the
paper (page 37), then continue with
step 3 of this procedure.
Open the printer cover.
Loosen the two hinge adjustment
thumbscrews.
Slide the cover upward until it stops.
Tighten the two hinge adjustment
thumbscrews.
Place the paper guide in its upper
position.
Load paper (page 22), feeding the paper
out the top paper exit.
To Next Page
Loading...
