22 Operator’s Guide
This procedure shows you how to load
paper. Use this procedure to load paper into
an empty printer, change the paper supply to
a different size, or load paper after clearing a
paper jam.
To reload the paper after an “END OF
FORMS” fault message, refer to page 29.
Press Stop to place the printer in
NOT READY state.
Open the printer cover.
If necessary, unload the current
paper (page 37), then continue with
step 3 of this procedure.
Raise the forms thickness lever
as far as it will go.
Open both tractor doors.
Press any key on the operator panel
to silence the alarm.
Pressing any key on the operator panel will
silence the alarm . (Take care when pressing
the Form Feed key as the top–of–form
setting will be lost.)
Forms
Thickness
Lever
Tractor
Door
To Next Page
Loading...
