27Operator’s Guide
Lower the forms thickness lever.
Set it to match the paper
thickness (refer to the note on the
shuttle cover).
Do not set the forms thickness lever too
tightly; excessive friction can cause
paper jams, ribbon jams with potential
for ribbon damage, smeared ink, or
wavy print.
On pedestal models:
Guide the paper over the lower paper
guide and through the top or rear paper
exit.
Forms Thickness Lever
Thin Paper
Medium Paper
Thick Paper
Lower
Paper
Guide
Pedestal Models
NOTE:
Thin Paper = single sheet
Medium Paper = two–part form
Thick Paper = six–part form
To Next Page
Loading...
