28 Operator’s Guide
Do one of the following:
If there is data in the buffer, such as
after a paper jam, go to page 39 to
set the top-of-form.
If there is no data in the buffer,
continue with step 16 of this
procedure.
Press Form Feed several times to
ensure that the paper feeds properly
beyond the tractors, over the lower
paper guide, and into the paper stacking
area. Feed sufficient paper to ensure
that the paper stacks correctly. Ensure
that the paper folds the same way in the
stacking area as it does in the supply
area.
On cabinet models:
Open the cabinet rear door. Ensure that
the paper is aligned with the label in the
output area (inside the cabinet). Close
both doors, if the length of your forms
allows this. (Some longer forms may
require the doors be left open.)
Go to page 39 to set the top-of-form.
Lower Paper
Guide
Cabinet Models
To Next Page
Loading...
