31Operator’s Guide
Pull the new paper above and
behind the ribbon mask, but in
front of the existing paper. (The
ribbon mask location is shown on
the ribbon path diagram.)
If necessary, gently press the
existing paper back.
Align the top edge of the new
paper with the top perforation
of the existing paper.
Load the new paper over the
existing paper.
Open and load the tractors one
at a time to prevent the paper
from slipping.
Ensure that the top edge of the new paper
lines up with the top perforation of the
existing paper.
Existing
Paper
New Paper
Ribbon Path
Diagram
To Next Page
Loading...
