32 Operator’s Guide
6 Lower the forms thickness lever. Set
it to match the paper thickness.
(The A–B–C scale corresponds
approximately to 1–, 3–, and 6–part
paper thickness. Adjust until you
have the desired print quality.)
caution
Do not set the forms thickness lever too
tightly; excessive friction can cause
paper jams, ribbon jams with potential
for ribbon damage, smeared ink, or
wavy print.
7 Press Cancel to clear the
“END OF FORMS” fault
message from the Liquid
Crystal Display.
8 Close the printer cover.
Close the cabinet front door.
9 Press Start to place the printer
in READY state and resume
printing.
10 On cabinet models: Open the
cabinet back door and ensure
that the paper folds in the
stacker the same way it does in
the supply area, then close the
cabinet back door.
Perform steps 11 through 26 only if you are
unable to load the new paper over the
existing paper in step 3.
A
B
C
Thin Paper
Medium Paper
Thick Paper
NOTE:
Thin Paper = single sheet
Medium Paper = two–part form
Thick Paper = six–part form
To Next Page
Loading...
