36 Operator’s Guide
On cabinet models:
Make sure the paper is aligned
with the label in the output area
(inside the cabinet). Close the
front door.
Align the top of the first print
line with the TOF indicator on
the tractor by rotating the
vertical position knob.
Lower the forms thickness
lever. Set it to match the paper
thickness.
(The A–B–C scale corresponds
approximately to 1–, 3–, and
6–part paper thickness. Adjust
until you have the desired print
quality.)
Press Cancel to clear any fault
messages (such as “END OF
FORMS”) from the Liquid Crystal
Display.
Press Set Top Of Form. The
top–of–form you have set moves
down to the print position.
If there are data in the buffer, the
paper moves forward to the last
print position on the next page.
Press Start and close the printer
cover.
Thin Paper
Medium Paper
Thick Paper
NOTE:
Thin Paper = single sheet
Medium Paper = two–part form
Thick Paper = six–part form
To Next Page
Loading...
