38 Operator’s Guide
Remove the paper from the
tractors.
On cabinet models:
Open the cabinet front door.
For all models,
gently
pull the paper
down through the paper slot. Do not let
the paper perforations or tractor holes
damage the ribbon mask. (Refer to the
ribbon path diagram on the shuttle
cover.)
Allow the paper to fall into the paper
supply area.
<4> Be careful when pulling any paper
backwards through the paper path,
especially when using label stock. If you
are not careful, labels can detach and
adhere to the printer within the paper
path, where only an IBM service
representative can remove them.
On cabinet models:
Remove the paper supply from the
cabinet floor. Close the cabinet front
door and the printer cover.
On pedestal models:
Remove the paper supply from the floor
or shelf in front of the printer and close
the printer cover.
Cabinet
Front
Door
Pedestal Models
Cabinet Models
Ribbon Path Diagram
Tractor
To Next Page
Loading...
