Forms Thickness Lever
TOF
Indicator
Vertical
Position
Knob
39Operator’s Guide
The top-of-form setting determines where
the first line of print appears on a page.
Follow this procedure to set the
top-of-form.
If the printer is in READY state, press
Stop to place the printer in NOT READY
state.
Open the printer cover.
Raise the forms thickness lever as
far as it will go.
Press any key on the operator panel
to silence the alarm.
Locate the TOF indicator. It is the
small tab located on the left tractor
door.
Align the top of the first print line with
the TOF indicator on the tractor door
by rotating the vertical position knob
up or down.
To Next Page
Loading...
