Removing Power Supplies
Removing Power Supplies
Before you begin, be sure you have:
Read “Electrical Safety” on page 75 and “Handling
Static-Sensitive Devices” on page 77 (or your safety booklet).
Turned off peripheral devices (see “Preparing to Install
Options” on page 78).
9
CAUTION:
Power supplies are easy to install and remove, but they are
not hot-swappable. Always disconnect all server power
cords and all power supply power cords before you remove
or install a power supply.
To remove a power supply, do the following steps:
1. Locate the cover on the power-supply bay (at the back of the
power-supply chassis).
2. Remove the four screws from the cover.
3. Remove the power-supply cover and save for future use.
Chapter 4. Installing Options 197
To Next Page