@D.2.4 Installing the Power Management Device Driver for Windows 3.0
@The power management device driver program for Windows 3.0 is available.
@The program enables Windows 3.0 to work properly with suspend and resume
@modes.
@Warning: Unpredictable results can occur when power is suspended and
@later resumed if this driver is not used.
@If you installed Windows 3.0, do the following to install the power
@management device driver program for Windows 3.0.
@+--- Assumption ---------------------------------------------------------+
¦ ¦
@¦ The following steps assume: ¦
¦ ¦
@¦ You have installed Windows 3.0 in a directory called WINDOWS. If ¦
@¦ you named the directory something else, modify the installation ¦
@¦ target path during installation appropriately. For example, if ¦
$¦ Windows is installed in C:\WIN3, install the file to C:\WIN3 ¦
@¦ instead. ¦
¦ ¦
+------------------------------------------------------------------------+
$1. Insert the backup copy of the Reference Diskette into the diskette
$ drive.
$2. At the DOS prompt (usually C:\>), type A:UINSTALL and press Enter.
$ The following screen appears.
+-------------------------------------------------------------------------
¦
$ ¦ Installation Options
¦
$ ¦ ++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
$ ¦ Installation Source Drive
$ ¦
$ ¦ Enter the installation SOURCE drive letter, the drive that the program
$ ¦ installs FROM:
$ ¦
$ ¦ Source Drive ... [ A ]
$ ¦
$ ¦ Enter F1=Help F3=Exit
$ ¦ ++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
¦
$3. Press Enter twice.
$ The screen for selection appears.
$4. Using Down Arrow () or Up Arrow () select Install Windows 3.0 Power
$ Management Device Driver. Press Enter. Follow the instructions on
$ the screen.
$5. Remove the backup copy of the Reference Diskette from the diskette
$ drive.
PS/2 Model L40 SX Quick Reference
Installing the Power Management Device Driver for Windows 3.0
¦ Copyright IBM Corp. 1991
D.2.4 - 1
To Next Page
Loading...
Need help?
General