|3.5.2 Resume Mode
@The computer returns to resume mode when one of the following occurs.
@ Opening the computer after having placed it in suspend mode.
@ PICTURE 75
@ Note: When you open the display and successfully return to resume
@ mode, one beep sounds.
@ Issuing the PS2 ON at HH:MM:SS command in the Set features program
@ Activating the Ring Indicator on the communication interface.
@ Warning: To resume immediately after entering suspend mode adhere to
@ the following instructions to avoid losing data.
@ 1. Make sure that the computer has entered suspend mode (one beep) or
@ partial suspend mode (two beeps).
@ 2. Wait 10 seconds.
@ 3. Open the display.
@ Warning: If you do not follow the above instructions, the application
@ system may be stopped. In this case, you have to turn off and turn on
@ the computer to restart the application program.
|+--- Very Important -----------------------------------------------------+
¦ ¦
|¦ Before or when the computer returns to resume mode, the following ¦
|¦ should be considered. ¦
¦ ¦
+------------------------------------------------------------------------+
Subtopics
3.5.2.1 Considerations for Resume Mode
PS/2 Model L40 SX Quick Reference
Resume Mode
¦ Copyright IBM Corp. 1991
3.5.2 - 1
To Next Page
Loading...
Need help?
General