3.7.2 Network Server Mode
|If your computer is a server on a network, you can set the network server
mode. Before setting the network server mode, you must first set a
power-on password. To set a power-on password, see page 3.7.1. Your
|computer can now be turned on so other computers can access your hard disk
|while your keyboard is locked.
To set the network server mode
1. Start the backup copy of the Reference Diskette (see page 3.6.1).
2. Select Set passwords and network server mode on the Main Menu and
press Enter.
3. Select Set network server mode and press Enter. Follow the
instructions on the screen.
To remove the network server mode
1. Start the backup copy of the Reference Diskette (see page 3.6.1).
2. Select Set passwords and network server mode on the main menu and
press Enter.
3. Select Set network server mode and press Enter. Follow the
instructions on the screen.
4. When asked Set network server mode?, type N and press Enter.
PS/2 Model L40 SX Quick Reference
Network Server Mode
¦ Copyright IBM Corp. 1991
3.7.2 - 1
To Next Page
Loading...
Need help?
General