To Next Page

To Previous Page

#E.3.1 Installing the Large Pointer Program for OS/2

#To install this program, follow the steps below.

#1. Insert the backup copy of the Reference Diskette into the drive.

#2. At the OS/2 prompt, type:

# A:\LRGPTR2 /

style

/C:\L40SXUT

# and press Enter.

# Note: To select white large pointer, specify 1 for

style

. To select

# black large pointer, specify 2 for

style

#3. Using a non-formatting text editor, in the CONFIG.SYS file, add

# C:\L40SXUT to change the LIBPATH command line to read:

# LIBPATH=C:\L40SXUT;C:\OS2\DLL;. . .

#4. Remove the backup copy of the Reference Diskette from the drive.

#5. Shut down then restart OS/2.

# The pointer you selected is displayed.

#+--- Changing the Pointer Style -----------------------------------------+

¦ ¦

#¦ To change the pointer style from the once installed type to the other ¦

#¦ type, do the following. ¦

¦ ¦

#¦ 1. Delete C:\L40SXUT; from the LIBPATH command line of the CONFIG.SYS ¦

#¦ file. ¦

¦ ¦

#¦ 2. Shut down then restart OS/2. ¦

¦ ¦

#¦ 3. Perform again the procedures for installing the large pointer ¦

#¦ program. ¦

¦ ¦

+------------------------------------------------------------------------+

PS/2 Model L40 SX Quick Reference

Installing the Large Pointer Program for OS/2

E.3.1 - 1

IBM 8543 User Manual

Other manuals for IBM 8543