Table 5. Slot locations and descriptions for the EMX0 PCIe3 expansion drawer (continued)
Location code Description
Slot capabilities
SR-IOV Dynamic direct
memory access
(DMA) window
I/O adapter
enlarged capacity
enablement order
P2-C6 PCIe3 x8 Yes Yes No
1
Slots P1-C1 and P2-C1 inherit the I/O Adapter Enlarged Capacity attribute from the slot in the system
that connects to the EMX0 PCIe3 expansion drawer.
Notes:
• All slots are PCIe3 slots.
• All slots support full-length, full-height adapters or short form-factor with a full-height tailstock in
single-wide, generation 3, blind-swap cassettes.
• Slots C1 and C4 in each PCIe3 6-slot fanout module are PCIe3 x16 buses and slots C2, C3, C5, and C6
are PCIe x8 buses.
• All slots support enhanced error handling (EEH).
• All PCIe slots are hot swappable and can be serviced with the power on.
• All six adapters in a PCIe3 6-slot fanout module can be in SR-IOV shared mode.
• If you have a CCIN 50CB PCIe3 6-slot fanout module, the FC EC2S and FC EC2U adapters are only
supported in slots C2 and C5. If you have a CCIN 50CD PCIe3 6-slot fanout module, the FC EC2S and FC
EC2U adapters are supported in slots C1 through C6, but only four FC EC2S and FC EC2U adapters can
be in SR-IOV mode at a time.
Firmware slot capabilities
System PCIe slots are allocated direct memory access (DMA) space using the following algorithm:
• All slots are allocated a 2 GB default DMA window.
• Slots P1-C1 and P2-C1 inherit the I/O Adapter Enlarged Capacity attribute from the slot in the system
that connects to the EMX0 PCIe3 expansion drawer.
• All other I/O adapter slots are allocated Dynamic DMA Window (DDW) capability based on installed
platform memory. DDW capability is calculated assuming 4K I/O mappings:
– For systems with less than 64 GB of memory, slots are allocated no DDW capability.
– For systems with at least 64 GB of memory, but less than 128 GB of memory, slots are allocated 16
GB of DDW capability.
– For systems with at least 128 GB of memory, but less than 256GB of memory, slots are allocated 32
GB of DDW capability.
– For systems with 256 GB or more of memory, slots are allocated 64 GB of DDW capability.
Adapters placement rules
Use this information while selecting slots for installing adapters in the EMX0 PCIe3 expansion drawer
attached to the system. Use Table 6 on page 10
to identify slot placement priorities and the maximum
number of adapters that can be installed in the EMX0 PCIe3 expansion drawer based on the operating
system.
Note: You can click the link that appears in the feature code column for more technical information
specic to the adapter.
• If the EMX0 PCIe3 expansion drawer is congured with two PCIe3 6-slot fanout modules, distribute the
adapters across both I/O modules whenever possible.
Adapter placement for the 9040-MR9
9
To Next Page
Loading...
Need help?
General