19. From the list of displayed devices, select the device at which the service key
was inserted. In this example, the service key was inserted in the top slot of
the media tray on the front of the BladeCenter chassis.
20. Press Enter and the appliance boots from the service key. The system reboots
one or more times. The IBM System x screen might appear again. Let it time
out and proceed.
21. For a remote KVM session, you might see the following dialog. Select Yes and
the session should resume.
22. When you are prompted to enter the password, enter the password that
corresponds to the service key that is plugged into the chassis. This password
was obtained when the service key was created.
Removing and replacing blade server components 11
To Next Page
Loading...
Need help?
General