IBM BladeCenter Management Module - Restart MM; Network and Security Configuration; Configuring SNMP

Restart MM
Select the Restart MM choice to restart (reset) the management module. If a
second management module is present, select this choice to change to the
redundant management module.
Network and security configuration
The following sections describe how to configure management module networking
and security parameters for:
v SNMP and DNS (see “Configuring SNMP”)
v SMTP (see “Configuring SMTP” on page 37)
v SSL and LDAP (see “Configuring LDAP” on page 38)
v SSH (see “Configuring the secure shell server” on page 52)
Configuring SNMP
You can query the SNMP agent to collect the sysgroup information and to send
configured SNMP alerts to the configured host names or IP addresses.
Note: If you plan to configure Simple Network Management Protocol (SNMP) traps
on the management module, you must install and compile the management
information base (MIB) on your SNMP manager. The MIB supports SNMP
traps. The MIB is included in the management-module firmware update
package that you downloaded from the IBM Support Web site.
Complete the following steps to configure your SNMP:
1. Log in to the management module where you want to configure SNMP. For
more information, see “Starting the management-module Web interface” on
page 12
2. In the navigation pane, click MM Control → General Settings. In the
management-module information page that opens, specify the following
information:
Chapter 3. Using the management-module Web interface 35